Intermediate Level Rigging Training Course

REQUIRED SKILLS AND KNOWLEDGE

This section describes the pre-requisite skills and knowledge required for this unit.

ability to calculate Safe Working Load (SWL) and Working Load Limit (WLL)
ability to erect and dismantle, level, plumb and stabilise associated plant and structures
ability to work safely at heights including the correct application of safety equipment.
accurate interpretation of structural charts and structural plans (site information)correct application and use of all rigging and associated equipment
risk assessment and hazard control strategies
interpersonal and communication skills at a level sufficient to site/workplace requirements. This includes the relevant communication methods and equipment.
verify problems and equipment faults and demonstrate appropriate response.

appropriate mathematical procedures for estimation and measurement of loads
ability to interpret manufacturer’s specifications for all plant and equipment use in rigging operations
knowledge of principles relating to all plant, equipment and structural stability
knowledge of the types and functions of rigging, safety and associated equipment including an understanding of their limitations
organisational and workplace standards, requirements, policies and procedures for rigging
understanding of the hierarchy of hazard identification and control
relevant Commonwealth, state or territory and local government OHS legislation, standards and codes of practice for undertaking rigging activities
understanding of inspection and maintenance requirements of a wide range of appropriate plant and equipment in line with Australian Standards or manufacturer’s specifications
estimation of ground bearing pressures of the full range of soil types and associated ground conditions for setting up plant and equipment.

Task to be undertaken is assessed
Potential workplace hazards are identified
Hazard control measures are identified consistent with appropriate standards to ensure the safety of personnel and equipment
Site information is obtained
All forces and loads associated with erecting and dismantling structures and associated plant are considered in consultation with appropriate personnel .
Rigging equipment and associated equipment are identified in consultation with appropriate personnel according to procedures and site information.
Safety equipment is identified.
Appropriate communication methods are identified with appropriate personnel.

Rigging equipment and associated equipment are selected and inspected according to procedures and the appropriate Standard.
Safety equipment is selected and inspected according to procedures.
All defective rigging equipment, associated equipment and safety equipment is isolated, reported and recorded according to procedures.
Communication equipment is selected and inspected for serviceability (where applicable)

Appropriate hazard prevention /control measures are applied to the work area according to procedures.
Ground suitability is inspected and checked (where appropriate).
Site information is reviewed, interpreted and communicated to appropriate personnel and appropriate personnel .
All forces and loads associated with erecting and dismantling structures and associated plant are determined in consultation with appropriate personnel.
Safety equipment is fitted and worn correctly (where appropriate).
Rigging equipment and associated plant are positioned for work application and stability according to procedures.

Structures and associated plant is erected according to procedures and site information.
Stability of structures and associated plant is maintained during erection according to procedures.
Work is conducted safely at heights including safe and effective use of safety equipment.
Appropriate communication methods and communication equipment, are used to co-ordinate the tasks.
Temporary guys, ties, propping and shoring, including flexible steel wire rope , and tubing, are connected where required.
Associated plant and rigging equipment is used according to procedures and the appropriate standard.
Associated equipment is used in a safe and appropriate manner.
The completed task is inspected according to the appropriate standard.
Excess materials are removed from the work area (where applicable)

Structures and associated plant are dismantled according to procedures and the appropriate standard.
Work is conducted safely at heights including safe and effective use of safety equipment.
Stability of structures and associated plant is maintained during dismantling according to procedures.
Rigging equipment, associated equipment, safety equipment and associated plant are inspected for damage and defects
All defective rigging equipment, associated equipment, associated plant and safety equipment are isolated reported and recorded according to procedures.
Rigging equipment and associated equipment are stored according to procedures and the appropriate standard
Hazard prevention/control measures are removed (where appropriate)

Qualifications provided by partner organisations